Installing KW's how to?

I'v run into a small thing when installing the KW V1.

I presume this is the way it's supposed to be installed:

http://i16.photobucket.com/albums/b42/Maw…pg?t=1259873814

I'm a bit unsure if the nut I have that goes thru the "rubber", holding the bearing is wrong, as it doesn't go "thru" the rubber - it stops in the rubber, and I thought the rubber should rotate freely on the bearing??.

The nut I have used is this:

http://www.germanautoparts.com/images/7607a6e…3231343038413/f

Anyone have a pic of an OEM VW nut that goes in there?.

Or can tell me if this is right/wrong?

hmm ok, so then I presume the nut should be able to "go thru" the rubber without "stopping" in the rubber?...

btw, am I also supposed to use item nr 6 ? (I placed the bearing directly on the plastic), like this:

http://i16.photobucket.com/albums/b42/Maw…ul/DSCN1567.jpg

(the car haven't been down on the floor again yet though...;)

Zitat von mark76

No. No.6 is only needed if you ride on OEM Suspension.

Ok, thnx I presume the only thing I will do then is to put bearing over the purple plastiv, tighten it with the "flat" nut, and then put the rubber on - put it on the car and tighten at the top.

thnx again